Mirage LS Coupe DD build *New pic 04/05/13*

[miksatx]

Here's a pix of my intake mani.

[mycarlisa]

*flocks around in a vulture fashion* that ralliart airbag cover does look awfully fancy.

[MitsuMirageLs]

*flocks around in a vulture fashion* that ralliart airbag cover does look awfully fancy.

I took it off, not my thing lol. Also have to remove that tach

[mycarlisa]

I took it off, not my thing lol. Also have to remove that tach

*continues the vulture flocking* so what did you do with it? i mean if you are going to just throw it away... xD

[miksatx]

The little hose off the charcoal canister goes to the bottom metal tube it angles outward away from the intake. in the picture it just left of the throttle cable.

[miksatx]

Here's a pic for reference of how the sensors install.

[miksatx]

Here's vacuum diagram pix out the 97 service manual.

[miksatx]

The cruise hose goes on the brass colored bellows looking thing above where the end of the throttle cable hooks up. The middle pipe you asked about goes on the vacuum control valve.
The vacuum control valve bolts down on the bracket that connects to the engine block an the back of the intake manifold. Here this second pix of a reddish colored valve thingie is the vacuum control valve.

[miksatx]

El what you need to do is unhook the o2 sensor, coil wires and fuel injector clips and pull all that harness out of the way so you can see what your doing bro. It a bitch trying to work in that harness mess.

[miksatx]

El take the hose off the red egr solenoid the black end of it. Hook it to the other end of the vacuum pipe. Then take a short piece of hose connect it to the black end of the egr that you just removed the hose from and hook thhe short hose to the vacuum pipe in the pix you sent. This section of hoses are tee'd off a hose from the egr from there it goes to the vacuum control valve.
El this is the egr solenoid. In the picture you sent I see a hose on the black end of the sensor. The hose has a green strip on it

image.jpg (11.61 KiB) Viewed 759 times

[miksatx]

here's some clearer shots El

DSC00001.JPG (59.95 KiB) Viewed 752 times

DSC00002.JPG (61.27 KiB) Viewed 752 times

[MitsuMirageLs]

those help a lot! thanks man, ill finally be able to work on it again tomorrow. If the weather holds up, we keep getting rain when I have free time

[miksatx]

El the middle hose on the vacuum control valve goes to the vacuum pipe that goes to the E vacuum pipe on throttle body.

[miksatx]

Here's a pic of where the emission system is located on my 99 the emission canister is here not up front.